Table of Contents
Advertisement
Setting the clock
1
In standby mode or system on, press and hold
CLOCK SET on the remote control for more
than 3 seconds.
➜ SET CLOCK scrolls on the display.
➜ The clock digits for the hours flash.
Press VOLUME +/- to set the hours.
2
3
Press CLOCK SET again.
➜ The clock digits for the minutes flash.
Press VOLUME +/- to set the minutes.
4
5
Press CLOCK SET to confirm the time.
Note:
– The backlight for clock display is dim in standby.
Viewing the clock
Press CLOCK SET
➜ The clock time is displayed.
Setting the timer
● The system can be used as an alarm clock,
whereby the CD, TUNER is switched on at a set
time. The clock time needs to be set first before
the timer can be used.
● During setting, if no button is pressed within 90
seconds, the system will exit timer setting mode
automatically.
1
In standby mode or system on, press and hold
TIMER on the remote control for more than 3
seconds.
➜ SET TIMER and SELECT SOURCE scrolls
on the display.
Press SOURCE or VOLUME +/- to select
2
sound source.
➜ Display sequence shows CD, TUNER.
➜
flashes.
3
Press TIMER to confirm your desired mode.
Press VOLUME +/- to set the hours.
4
5
Press TIMER again.
➜ The clock digits for the minutes flash.
Press VOLUME +/- to set the minutes.
6
7
Press TIMER to confirm the time.
➜ The timer is now set and activated.
Activating and deactivating
TIMER
●
Press TIMER on the remote to turn off the
timer or turn on to the last setting again.
➜ If activated, the timer information will display
for a few seconds, then the system resumes to
the last active source or stays in standby mode.
➜ If deactivated, "OFF" appears.
Note:
– The system will exit timer setting mode if no
button is pressed within 90 seconds.
Activating and deactivating
SLEEP
The sleep timer enables the system to switch off
by itself after a set period of time.
● Press SLEEP on the remote control once or
more.
➜ Display shows SLEEP and
one of the sleep time options
in sequence: 90, 75, 60,...,
45,30,15, OFF, 90. if you have
selected a time. Once SLEEP is
activated, SLEEP is display.
● To deactivate, press SLEEP on the remote
control once or more until OFF is shown, or
press STANDBY-ON on the system or
remote control.
Clock/Timer
17
Advertisement
Table of Contents
