Table of Contents
Advertisement
Radio Reception
Tuning to radio stations
1
Press SOURCE to select TUNER.
➜ TUNER is displayed briefly.
2
Press BAND (or TUNER on the remote
control) once or more to select your waveband
(FM/ MW).
Press and hold TUNE à or á.
3
➜ The radio automatically tunes to a station
with sufficient reception. Display indication during
automatic tuning: SEARCH.
4
Repeat step 3 if necessary until you find the
desired station.
● To tune to a weak station, press TUNE à or
á briefly and repeatedly until you have found
optimal reception.
Programming radio stations
You can store up to a total of 40 radio stations
in the memory.
Automatic programming
Automatic programming will start with a chosen
preset number. From this preset number
upwards, former programmed radio stations will
be overridden. The system will only program
stations which are not in the memory already.
Press PRESET ¡ or ™ to select the preset
1
number where programming should start.
Note:
– If no preset number is selected, default is preset
(1) and all your presets will be overridden.
14
2
Press PROGRAM for more than 2 seconds to
activate programming.
➜ AUTO is displayed and available stations are
programmed in order of waveband reception
strength: RDS, FM followed by MW. The last
preset automatically stored will then be played.
Manual programming
1
Tune to your desired station (see "Tuning to
radio stations").
2
Press PROGRAM to activate programming.
Press PRESET ¡ or ™ to allocate a number
3
from 1 to 40 to this station.
4
Press PROGRAM again to confirm the setting.
➜ The preset number and the frequency of the
preset station are shown.
5
Repeat the above four steps to store other
stations.
● You can override a preset station by storing
another frequency in its place.
Tuning to preset radio stations
● Press PRESET ¡ or ™ until the desired preset
station is displayed.
Advertisement
Table of Contents
