Table of Contents
Advertisement
WARNING
Under no circumstances should you try to repair the system yourself, as this will invalidate the
warranty. Do not open the system as there is a risk of electric shock.
If a fault occurs, first check the points listed below before taking the system for repair. If you
are unable to remedy a problem by following these hints, consult your dealer or Philips for help.
Problem
CD OPERATION
"NO DISC" is displayed.
RADIO RECEPTION
Radio reception is poor.
GENERAL
The system does not react when buttons
are pressed.
Sound cannot be heard or is of poor
quality.
The left and right sound outputs are
reversed.
The remote control does not function
properly.
The timer is not working.
The Clock/Timer setting is erased.
Troubleshooting
Solution
– Insert a disc.
– Check if the disc is inserted upside down.
– Wait until the moisture condensation at the lens
has cleared.
– Replace or clean the disc, see "Maintenance".
– Use a finalised CD-RW or CD-R.
– If the signal is too weak, adjust the antenna or
connect an external antenna for better reception.
– Increase the distance between the Micro HiFi
System and your TV or VCR.
– Remove and reconnect the AC power plug and
switch on the system again.
– Adjust the volume.
– Disconnect the headphones.
– Check that the speakers are connected correctly.
– Check if the stripped speaker wire is clamped.
– Check the speaker connections and location.
– Select the source (CD or TUNER, for example)
before pressing the function button (É Å,í,
ë).
– Reduce the distance between the remote control
and the system.
– Insert the battery with its polarities
(+/– signs) aligned as indicated.
– Replace the battery.
– Point the remote control directly toward
IR sensor on the front of the system.
– Set the clock correctly.
– Press TIMER to switch on the timer.
– Power has been interrupted or the power cord
has been disconnected. Reset the clock/timer.
19
Advertisement
Table of Contents
