Problems And Corrective Actions - Krups EA894 EVIDENCE PLUS Manual

You can also start the descaling program when you want:
- Fill the water tank up to the CALC mark.
- Pour the dose of descaler into the water tank.
- Press the Settings button
- Select Maintenance.
- Then Descaling.
!
Important: if you unplug your machine during cleaning or in the event of electrical failure, the descaling program
will resume the current step at the time of the incident. It will not be possible to postpone this operation.
Complete the full descaling cycle in order to remove all traces of the descaling product which is harmful
to health.
Si l'un des problèmes énoncés dans le tableau persiste, appelez le service consommateurs KRUPS.
PRObLEm
The machine displays a fault, the software
is frozen.
OR
Your machine has a malfunction.
The device does not turn on after pressing
the On/Off button (for at least 3 seconds).
The appliance must be disconnected and
reconnected.
A power failure has occurred during a cycle. The device resets automatically when when it turns back on.
The grinder makes an abnormal noise.
There is water under the device.
When switching off, hot water flows through
the coffee outputs and the One Touch
Cappuccino block.
The adjustment button for the grinding
fineness is difficult to turn.
The device has not issued any coffee.
You have used ground coffee instead of
coffee beans.
36
.

PRObLEmS AND CORRECTIVE ACTIONS

CORRECTIVE ACTIONS
Turn off and unplug the machine, remove the filter cartridge, wait
a minute and restart the machine.
Press and hold the on/off button for at least 3 seconds for
starting.
Check the fuses and the power socket of your electrical
installation.
Check that the two power plugs are correctly inserted into the
socket.
Unplug the appliance for 20 seconds, remove the Claris Aqua
Filter System cartridge if necessary, then put it back into service.
Foreign bodies are surely present in the grinder.
Before removing the water tank, wait 15 seconds after the flow of
coffee so that the machine finishes its cycle correctly.
Verify that the drip tray is well positioned on the machine. It must
always be in place even when the machine is not in use.
Verify that the drip tray is not full.
Depending on the type of preparation the machine can perform
automatic rinsing during its powering off.
The cycle lasts only a few seconds and stops automatically.
Turn the adjustment button of the grinding fineness only when
the grinder is operating.
An incident has been detected during its making.
The device is reset automatically and is ready for a new cycle.
Use your vacuum cleaner to collect the ground coffee contained
in the bean container.