For Gug-03Sl-E - Mitsubishi Electric GUG-01SL-E Handbook

For GUG-03SL-E

1 Remove the following covers from the Dx-coil unit.
a. Unscrew the screws (six special screws 4×14, shown
in the photo below) to remove the drain socket cover.
→ See (4) 2 .
b. Unscrew the screws (five special screws 4×14, shown
in the photo below) to remove the maintenance cover
C. → See (7) 1 .
2 Cut the cord bands, and remove the thermistors (TH2, TH5) from the holders.
Thermistor (TH5)
(The longer one with a black connector)
When reassembling
Reassemble the unit in the reverse order of disassembly.
After reassembly, always make a test run to be sure that
the unit operates properly.
Drain socket cover
Heat exchanger
─ 43 ─
Maintenance cover C
Thermistor (TH2)
(The shorter one with a white connector)