For GUG-03SL-E
1 Remove the drain pump assembly. → See (4).
2 Unscrew the screws (two PTT screws 4×8, indicated by
and shown in the photo below), and remove the fix
plate for the water sensor.
3 Unscrew the screw (one spl screw 4×12, indicated by
and shown in the photo below) to remove the water sensor.
Thermistor parts
Before disassembling, remove the connector of each lead wire from PCB B.
( 6 ) Remove the thermistor (TH11: Inlet air temperature thermistor)
1 Remove the drain socket cover. → See (4) 2.
2 Unscrew the screws (two PTT screws 4×8, indicated by and shown in the photo below), and pull out the
thermistor fixing plate.
For GUG-01SL-E and GUG-02SL-E
Thermistor fixing plate
3 Loosen the lead wire clip, and remove the thermistor
(TH11).
(Non-shiny)
(Non-shiny)
For GUG-03SL-E
─ 39 ─
Water sensor
Thermistor fixing plate
Lead wire clip
Thermistor fixing plate
Fix plate
Thermistor (TH11)