Advertisement
7.
Insert steel ball into hole at back of carriage
(see Figure 8) and secure by screwing in
lock handle. Use this handle to position and
lock carriage at different measurements.
Carriage
Steel Ball
(hidden)
Figure 8. Steel ball secured by lock handle.
8.
Set and lock measuring gauge at 0" then line
up push bar mounts at base of carriage (see
Figure 9). Slide push bar through mounts
with workpiece stop positioned on bandsaw
side.
Push Bar
Mounts
Figure 9. Push bar and mounts.
T28941 Work Stop Measuring System (Mfd. 6/19+)
Lock Handle
9.
Align workpiece stop with workpiece where it
will contact bandsaw blade (see Figure 10).
Bandsaw
Blade
Work Stop
Figure 10. Push bar aligned with workpiece
cutting point.
10. Tighten pre-installed hardware in bar mounts.
11. For cuts larger than 8", attach workpiece
guide to workpiece stop by screwing guide
threads into corner hole of stop (see Figure
11).
Stop
Figure 11. Workpiece guide and stop. (Other
assembled parts removed for clarity).
Guide
-3-
Advertisement
