Advertisement
Assembly
1.
Attach rail extension to carriage rail with
extension bracket and (4) M6-1 x 12 cap
screws (see Figure 3). Attach rail extension
to side of carriage rail shown in Figure 4, as
it will need clearance when rail is attached to
machine.
Extension
Figure 3. Rail extension attached to carriage rail.
2.
Attach carriage rail to roller table using (4)
M8-1.25 x 55 cap screws, (4) 8mm washers,
and (4) spacers (see Figure 4).
Measuring Tape
0"
x4
Figure 4. Roller table with extended rail.
3.
Unroll measuring tape and affix to the full
measuring rail assembled in Step 2. Take
care to line up the edge, beginning at 0" (see
Figure 4).
-2-
Bracket
Carriage Rail
Rail Extension
4.
Attach workpiece stop to end of push bar
using (2) M6-1 x 16 hex bolts (see Figure 5).
Push Bar
Figure 5. Workpiece stop and push bar.
5.
Slide carriage onto measuring rail. Measure
gauge on carriage should depict measur-
ing numbers, or carriage is backwards (see
Figure 6).
Measuring Rail
Figure 6. Assembled carriage and rail (roller
table removed for clarity).
6.
Thread M8-1.25 x 10 cap screw into end of
rail extension to secure (see Figure 7).
Figure 7. Rail extension cap screw.
T28941 Work Stop Measuring System (Mfd. 6/19+)
Workpiece
Stop
Measure
Gauge
Advertisement
