Table of Contents
Advertisement
Access Modular
Controller
5.3
Resetting the AMC2
If problems occur, they should first be tackled directly - for
example check the Network connection, IP-address and DIL
switch settings. Nevertheless it is sometimes an indirect help to
reset the AMC2-4R4 unit to its factory defaults.
5.3.1
Resetting the Software
1.
2.
3.
As soon as it is online again, the AMC2-4R4 bootloader will
download a fresh copy of the application program and
configuration. If the problem persists please request technical
support.
Figure 5.2: Resetting the AMC2
Bosch Sicherheitssysteme GmbH
Insert the provided screwdriver into the hole until it
reaches the reset button as shown in the figure below.
Press the reset button for at least three seconds.
The AMC2-4R4 deletes its application program leaving only
its bootloader and network setting.
Operating | en
2013-08 | AMC2-4R4 |
53
Advertisement
Table of Contents
