Extron electronics PIP 422 User Manual page 3

im Vertrieb von
Quick Start — PIP 422 and PIP 444
Installation
Step 1
For tabletop placement, install the four rubber
feet on the bottom of the PIP picture-in-picture
processor. Otherwise, mount the processor in a
rack using the included rack ears or install the
processor in furniture.
Step 2
Turn off power to the input and output devices,
and remove the power cords from them.
Step 3
Input connectors — Connect up to two (PIP 422)
or four (PIP 444) component video, S-video, or
composite video input devices to the top (input)
set of rear panel Inputs BNC connectors (3, 4).
Step 4
Loop-through connectors — If desired, connect
up to two (PIP 422) or four (PIP 444) component
video, S-video, or composite video display
devices to the bottom (buffered loop-through) set
of rear panel Inputs BNC connectors (3, 4).
3, 4 Component Video
1
I
Input
N
P
U
T
Buffered
S
Loop-through
S-Video
1
I
Input
N
P
U
T
Buffered
S
Loop-through
Composite Video
1
I
Input
N
P
U
T
Buffered
S
Loop-through
www.camboard.de
CAMBOARD Electronics
R-Y Y/VID B-Y/C
R-Y Y/VID B-Y/C
R-Y Y/VID B-Y/C
Tel. 07131 911201
PIP 422 and PIP 444 Picture-in-Picture Processors • Quick Start
Fax 07131 911203
Step 5
Output connectors — Connect a component
video, S-video, and/or composite video display
device to the rear panel Output BNC connectors (5).
The component video, S-video, and
composite video outputs are all active
simultaneously, so multiple displays can
be connected.
Component video
5
VIDEO
O
U
T
P
U
T
S
R-Y
S-Video
VIDEO
O
U
T
P
U
T
S
R-Y
Composite Video
VIDEO
O
U
T
P
U
T
S
R-Y
Step 6 (PIP 444 only)
Genlock connectors —
In(put) connector — If
desired, connect an external
black burst signal to the rear
panel Genlock Input BNC
connector for genlocking the
video signal in broadcast or
other sync-critical applications (6).
Out(put) connector — Connect any downstream
equipment that requires genlocking to the rear
panel Genlock Output BNC connector to route
the black burst signal throughout the system in
broadcast or other sync-critical applications.
If no device is connected to the output,
terminate the Genlock output with the
included 75-ohm terminator .
ce-info@camboard.de
C
Y
Y B-Y
C
Y
Y B-Y
C
Y
Y B-Y
6
IN
G
E
N
L
O
C
K
OUT
QS-1