Toro Multi Pro 5700-D Service Manual page 149

4. If boom valve motor assembly is to be removed:
A. Unplug machine wire harness connectors from
boom valve motor(s).
B. Remove pressure gauge tube from boom valve
motor assembly.
C. Remove fasteners that secure boom valve mo-
tors to mount bracket (Fig. 22 or 23).
D. Remove boom valve motor assembly from ma-
chine.
5. If agitation valve motor is to be removed:
A. Unplug machine wire harness connectors from
agitation valve motor.
B. Remove fasteners that secure agitation valve
motor to mount bracket (Fig. 22 or 23).
C. Remove agitation valve motor from machine.
6. Remove additional spray control components as re-
quired using Figure 20 as a guide. Discard all removed
O--rings and gaskets.
Assembly (Fig. 20)
NOTE: Coat all O--rings with vegetable oil before instal-
lation to reduce the chance of damage during assembly.
1. Install spray control components using Figure 20 as
a guide. Replace all removed O--rings and gaskets.
2. Position removed motor assembly to mount bracket
and secure with fasteners removed during disassembly
(Fig. 22 or 23).
3. On machines with serial number below 310000000,
secure support bracket to mount bracket with two (2)
flange head screws and flange nuts.
4. Install hoses to correct locations on spray control as-
sembly (Fig. 21). Secure hoses with hose clamps.
5. If removed, install pressure gauge tube to boom
valve motor assembly.
6. Plug machine wire harness connectors to valve mo-
tor(s).
7. Operate spray system and check for leaks.
Multi Pro 5700--D
SERIAL NUMBER BELOW 310000000
1
2
6
1. Agitation valve motor
2. Agitation supply hose
3. LH boom valve motor
SERIAL NUMBER BELOW 310000000
2
1. Boom valve motors
2. Agitation valve motor
SERIAL NUMBER ABOVE 310000000
2
3
1
1. Boom valve motors
2. Agitation valve motor
Rev. D
Page 6 - - 21
4
5
3
6
Figure 21
4. Center boom valve motor
5. RH boom valve motor
6. Boom supply hose
1
3
4
Figure 22
3. Flange head screw
4. Flange nut
3
Figure 23
3. Flange head screw
4. Flange nut
Spray System
6
3
4