Traction Speed Sensor - Toro Multi Pro 5700-D Service Manual

Traction Speed Sensor

Removal (Fig. 45)
1. Locate speed sensor on right side wheel motor. Dis-
connect speed sensor from machine wire harness.
2. Loosen lock nut and remove speed sensor from
wheel motor.
Installation (Fig. 45)
1. Thread lock nut fully onto speed sensor threads.
2. Center a wheel motor piston in the center of the sen-
sor port (see Sensor Port View in Fig. 46). Use a suitable
tool to feel when a motor piston is in the center of the
sensor port.
3. Lubricate O-ring and install onto sensor threads.
4. Thread sensor into port until sensor contacts piston.
Rotate motor output shaft one complete revolution to
make sure it rotates freely.
5. Turn sensor out (counter-clockwise) until angle be-
tween sensor orientation grooves and motor centerline
o o
is between 90 and 93
turn. Hold sensor at this position and torque lock nut
from 75 to 125 in-lb (8.5 to 14.1 N--m).
6. Plug speed sensor connector into machine wire har-
ness.
Orientation
Grooves
Speed Sensor
Piston
SENSOR SIDE VIEW
Electrical System
, then back out sensor one full
Lock Nut
1. Speed sensor
2. O- -ring
SENSOR PORT VIEW
Sensor Port
CORRECT
POSITION
SENSOR INSTALLATION
90
Figure 46
Rev. C
Page 5 - - 28
1
2
3
Figure 45
3. RH wheel motor housing
4. Motor piston group
Sensor Port
Piston
INCORRECT
POSITION
Motor
o o
to 93
Centerline
Multi Pro 5700--D
4
Piston
Orientation
Grooves