Subscribe to Our Youtube Channel
Related Manuals for Tucker Barbecues S Wok
Summary of Contents for Tucker Barbecues S Wok
- Page 1 ASSEMBLY , INSTALLATION AND OPERATING INSTRUCTIONS FOR S WOK AND ST WOK IMPORTANT – PLEASE READ ALL INSTRUCTIONS BEFORE YOU ASSEMBLE, INSTALL OR OPERATE THIS APPLIANCE. V12.06.19...
-
Page 2: Table Of Contents
CONTENTS GENERAL WARNINGS WOK ASSEMBLY INSTRUCTIONS INSTALLATION INSTRUCTIONS & WARNINGS SPECIFICATIONS DIMENSIONS GAS INSTALLATION AND LEAK TEST PROCEDURE WOK OPERATING INSTRUCTIONS TROUBLESHOOTING SERVICE & MAINTENANCE WARRANTY... -
Page 3: General Warnings
IMPORTANT SAFETY INSTRUCTIONS • Tucker S Wok and ST Wok are approved for • Read all instructions carefully before outdoor use only. assembly and usage of the Wok. • Remove all plastic protection film from • Do not use or store flammable materials in or stainless steel components before assembly. -
Page 4: Wok Assembly Instructions
WOK ASSEMBLY INSTRUCTIONS Tools required for assembly – shifting spanner and a Phillips head screwdriver. 1. Always remove any plastic protection film covering the Wok and components before assembly. 2. Cut away any packaging cable ties that are holding the parts in place. 3. - Page 5 3. Now make sure the 2 x enamel burner ring tops are in place over the burners and the wok is assembled. NOTE: Once you have assembled the Wok wipe it over to remove greasy fingerprints with stainless steel polish and a soft cloth.
-
Page 6: Installation Instructions & Warnings
INSTALLATION INSTRUCTIONS & WARNINGS WOK INSTALLATION INSTRUCTIONS READ THE IMPORTANT INFORMATION ON THE LID OF THE WOK. This Wok is designed and approved for outdoor use only. Be mindful of the location of installation of the Wok,strong winds blowing across the Wok whilst cooking can cause the Wok to blow out. - Page 7 DIAGRAMMATICAL REPRESENTATIONS OF FIGURE 4 OUTDOOR AREA –EXAMPLE 4 OUTDOOR AREAS The following figures are diagrammatical representations of outdoor areas. The areas used in the figures below are examples – the same principles apply to any other shaped area. FIGURE F1 – OUTDOOR AREA – EXAMPLE 1 Open side at least 30% or more in total 25% of total wall area...
-
Page 8: Specifications
SPECIFICATIONS S WOK GAS CONSUMPTION TUCKER S WOKS ARE MADE AND APPROVED TO AUSTRALIAN STANDARDS A.G.A. (In Mega Joules Per Hour) APPROVAL NO. AGA 8236-G Model Natural Gas LPG: For LP Gas connections, an approved 2.75 KPA regulator and hose assembly connection to the appliance is fitted by the manufacturer. -
Page 9: Dimensions
387mm 52mm 317mm 15mm 470mm ø130mm 192mm 360mm 192mm S WOK CUT-OUT DIMENSIONS CLEARANCES TO COMBUSTIBLE MATERIALS ARE AS FOLLOWS: Minimum Side Clearance Allow 200mm 345mm 455mm Minimum Rear Clearance Allow 200mm Minimum Top Clearance Allow 800mm 145mm NOTE: The wall surfaces above the Wok cooking... -
Page 10: Gas Installation And Leak Test Procedure
GAS INSTALLATION AND LEAK TEST PROCEDURE CONNECTION OF A GAS CYLINDER TO THE WOK IS AS FOLLOWS The hose assembly connection to the appliance is fitted by the manufacturer. WARNING: There must be no naked flames in the area when connecting the Wok to a gas supply. - Page 11 OPTIONAL ST WOK INSTALLATION TO A TUCKER BBQ CABINET TROLLEY. For the attachment of a ST Wok you will need to disconnect the existing hose connected to the inlet of the Barbecue and re-connect this hose to the inlet on the right-hand side of the Wok. Connect the shorter Wok hose to the outlet on the left-hand side of the Wok and connect the other end of the hose to the BBQ inlet.
- Page 12 GAS INSTALLATION PROPANE GAS TO NATURAL GAS CONVERSION PROCEDURE FOR NOTE: Check for leaks after each gas refill. AUTHORIZED INSTALLER Check that the hose is not kinked or under • Disconnect and remove the top part of the tension. Wok burner and 2 black enamel rings from Apart from the connection point the hose must the Wok.
-
Page 13: Wok Operating Instructions
WOK OPERATING INSTRUCTIONS MANUAL LIGHTING INSTRUCTIONS 1. Open the lid before lighting the Wok. 2. Turn the gas control knob to the OFF position. To light the Wok manually place a lit match next (clockwise). to the burner and turn the control knob to High. 3. -
Page 14: Troubleshooting
TROUBLESHOOTING TROUBLESHOOTING SOLUTIONS • Wok won’t light? Check gas connections and that the gas bottle has gas. • Ignition is not working? Check the ignition for a spark and adjust the spark gap to make sure the gap is 5-7mm from the ports on the burner. -
Page 15: Service & Maintenance
SERVICE & MAINTENANCE 1. Clean grease collection tray after each use, 11. Check and tighten nuts and bolts on the check before each use. Fat/grease fires are Wok body and Cabinet Trolley periodically if not covered by warranty. connected to a Tucker Cabinet Trolley. 2. -
Page 16: Warranty
WARRANTY TUCKER WOK WARRANTY 3. Installation must conform to the standards laid down by the local codes or, in the WARRANTY PERIOD absence of local codes, with AGA code AG:601 AS:5601:2002 Stainless steel body 5 years 4. No alterations or repairs are to be carried Gas manifold 5 years out without obtaining the distributors prior...
Need help?
Do you have a question about the S Wok and is the answer not in the manual?
Questions and answers