Ethernet And Console Ports; Status Leds - Aerohive AP120 Hardware Reference Manual

Table 1 HiveManager component descriptions (Continued)
Component
AC power inlet
On/Off switch
Power fan

Ethernet and Console Ports

The two 10/100/1000-Mbps Ethernet ports on the HiveManager labeled MGT and LAN use standard RJ45
connector pin assignments that follow the TIA/EIA-568-B standard (see
standard cat3, cat5, cat5e, or cat6 Ethernet cable. Because the ports have autosensing capabilities, the
wiring termination in the Ethernet cables can be either straight-through or crossover.
The default IP address/netmask for the MGT interface is 192.168.2.10/24. For the LAN interface, the
default IP address/netmask is 192.168.3.10/24. The IP address of the default gateway is 192.168.2.1.
The pin assignments in the male DB9 Console port follow the EIA (Electronic Industries Alliance) RS-232
standard. To make a serial connection between your management system and the Console port on the
HiveManager, you can use a null modem serial cable, use another serial cable that complies with the RS-232
standard, or refer to the pin-to-signal mapping shown in
make your own serial cable. Connect one end of the cable to the Console port on the HiveManager and
the other end to the serial (or COM) port on your management system. The management system must have
a VT100 terminal emulation program, such as Tera Term Pro
®
Hyperterminal (provided with Windows
The serial connection settings are as follows:
• Bits per second: 9600
• Data bits: 8
• Parity: none
• Stop bits: 1
• Flow control: none

Status LEDs

The two status LEDs on the front of the HiveManager indicate various states of activity through color (dark,
green, amber) and illumination patterns (steady glow or blinking). The meanings of the various color and
illumination patterns for each LED are shown in
Figure 2 Status LEDs
Steady illumination: Powered
Hardware Reference Guide
Description
The three-prong AC power inlet is a C14 chassis plug through which you can
connect a HiveManager to a 100 – 240-volt AC power source using the
10-amp/125-volt IEC power cord that ships with the product.
The on ( | ) and off (  ) switch controls the power to the HiveManager.
The fan that maintains the temperature of the power supply.
®
operating systems).
System power
Dark: no power
"DB9 Console Port Pin Assignments" on page 114
©
(a free terminal emulator) or Hilgraeve
Figure 2.
Hard disk drive
Dark: Idle
Blinking: Active
P
RODUCT
Figure 3 on page 111). They accept
O
VERVIEW
to
105