Surface Mount - Aerohive AP120 Hardware Reference Manual

Surface Mount

You can use the mounting plate to attach the AP340 to any surface that supports its weight, and to which
you can screw or nail the plate. First, mount the plate to the surface. Then, through one of the two large
openings in the plate, make a hole in the wall so that you can pass the cables through to the AP.
You can tie the cables to the tie points on the mounting plate to prevent them from being pulled
out of their connections accidentally.
Finally, attach the device to the plate, and connect the cables, as shown in
Figure 14 Mounting the AP340 on a wall
(Side view)
Hardware Reference Guide
1
Orient the mounting plate as shown and
attach it to a secure object such as a wall
post or beam. Use #8 screws for the oblong
holes, or #10 screws for the larger round
holes.
2
Cut or drill a hole through the large space
near the bottom of the mounting plate to
pass the cables through to the AP.
3
Insert the tabs on the mounting plate into
the slots on the underside of the AP. Then
push the AP downward to lock it in place.
4
Connect the cables to the AP.
Depending on the deployment, you might
connect one or two Ethernet cables and a
power cable.
Note: There are a variety of holes through which
you can screw or nail the plate in place. Choose the
two or three that best suit the object to which you
are attaching it.
M
Figure 14.
Mounting plate
AP
AP340
OUNTING THE
Wall
Wall
61