Aerohive AP120 Hardware Reference Manual page 39

Figure 7 Placement of Ethernet protector in relation to the network
= Ethernet cable
= Wireless link
To network
To network
To network
*To network
* This arrangement does not require an Ethernet protector
because it is built into the outdoor PoE injector.
To network through an AP neighbor
In the last case, the AP is a mesh point, connecting to
the Ethernet network through another AP.
1. Attach the Ethernet protection device to the building at the entry point of the shielded Ethernet cable
from the AP170.
2. Make the following connections, as shown in
• Ground the device by running a wire from the grounding stud to a grounded object, such as a water
pipe, gas pipe, or grounding rod.
• Connect the shielded Ethernet cable from the AP170 to the port labeled "Line Side", and connect
another Ethernet cable from the port labeled "Equipment Side" to the network.
Figure 8 Connecting the Ethernet protection device (SKU AH-ACC-1G-ETH-PROT)
To a grounded object
To a switch, PoE switch,
or indoor PoE injector
inline to the network
Hardware Reference Guide
Switch
PoE Switch
Indoor PoE
Injector
Switch
Figure
Grounding wire
Ethernet cable
Indoors
Ethernet Outdoor PoE
Protector injector
Ethernet
Protector
Ethernet
Protector
Outdoor PoE
Injector
Outdoor PoE
injector
8:
Ethernet Protection Device
(AH-ACC-1G-ETH-PROT)
Shielded Ethernet cable
P E E P
O AND THERNET ROTECTION
AP170 outdoors
To the AP170 or to an
outdoor PoE injector
inline to the AP70
37