Table of Contents
Advertisement
16 www.electrolux.com
Installing the shelf supports
Install the shelf supports in the opposite
sequence.
The rounded ends of the shelf
supports must point to the front.
9.3 Aqua cleaning
The Aqua cleaning procedure uses steam
to help remove remaining fat and food
particles from the oven.
1. Put 300 ml of water into the Aqua
cleaning container at the bottom of the
oven.
2. Set the oven function
3. Set the temperature to 90 °C.
4. Let the appliance operate for 30 mi-
nutes.
5. Deactivate the appliance and let it cool
down.
6. When the appliance is cool, clean the
inner surfaces of the oven with a cloth.
WARNING!
Make sure that the appliance is
cool before you touch it. There is
a risk of burns.
9.4 Oven lamp
WARNING!
Be careful when you change the
oven lamp. There is a risk of elec-
trical shock.
2
1
.
2.
Pull the rear end of the shelf support
away from the side wall and remove
it.
Before you change the oven lamp:
• Deactivate the oven.
• Remove the fuses in the fuse box or
deactivate the circuit breaker.
Put a cloth on the bottom of the
oven to prevent damage to the
oven light and glass cover.
Always hold the halogen lamp
with a cloth to prevent grease res-
idue from burning on the lamp.
1.
Turn the glass cover counterclock-
wise to remove it.
2.
Clean the glass cover.
3.
Replace the oven light bulb with an
applicable 300 °C heat-resistant oven
light bulb.
Use the same oven lamp type.
4.
Install the glass cover.
9.5 Cleaning the oven door
The oven door has three panels of glass.
You can remove the oven door and the
internal glass panels to clean them.
CAUTION!
Do not use the appliance without
the glass panels.
The oven door can close if you try
to remove the glass panels before
you remove the oven door.
Advertisement
Table of Contents
