Table of Contents
Advertisement
Safety Instructions
The equipment should only be used by trained operators, who
know the function of the unit well.
The installation of the working area has to correspond to the
relevant regulations. Set up the unit in such a way, that the
louvers are not covered and the extracted air can escape well.
To avoid the risk of an electric shock, this device might only be
connected to a power supply with protective conductor.
If you pull the power plug, it will stop the connection to the
mains power supply. Set up the unit so that the power plug is
always accessible. The power switch should also always be
easily accessible.
Only switch on the unit if the hand piece rests secured in the
hand piece holder, or if you hold it safely in your hand.
Prevent the permeation of liquids into the control unit. The
electronic elements could be damaged. Clean the outside of the
box only with a damped cloth. Be sure you unplug the unit
before.
Only when pulling the mains cable, you can ensure that the
device will be completely disconnected from mains. Check the
mains cable regularly for damages and in case of such let it
change or repair from an authorized service center.
Prevent your hair from wrapping itself around moving parts. If
applicable, wear a hair net.
When working with materials which might create dust or
moisture use a drilling unit with suction- or spray technique.
Wear a nose and mouth protection. Always follow the safety
instructions provided by the manufacturer of the materials being
formed.
4
Advertisement
Table of Contents
