Application; Operation Steps - hadewe Hyperios4 CHROME Manual

Application

Operation steps

In the following section the order in
which you should use the device is
described. Additionally, the individ-
ual steps will be explained in detail.
Read the complete manual before
use.
After connecting the device to the
power press the standby button (14)
to make it start rotating. Use the (3)
and (4) buttons to select a rotation
speed. Manufacturers often provide
recommendations for optimal rota-
tion speeds. However, it is im-
portant that you never exceed the
maximum recommended rotation
speed.
You can now choose a rotation
direction using the button (6). The
most commonly used direction is
clockwise. Most milling instrument
(steel instruments with steel cutters)
are optimized for clockwise use.
The rotation direction is irrelevant
for diamond cutters and high-grade
corundum sanders in terms of effi-
ciency. Working anti-clockwise can
be beneficial if, for example, the
dust obscures your field of vision
when working clockwise.
Now, you can turn on the spray by
pushing button (2). By using the
adjusting knob (1), you can set the
amount of the spray liquid.
After setting the speed and the
spray amount, you can start with
working.
If you want to take a break or finish
the job, press the standby button
(14). The hand piece motor and
spray will turn off. The hand piece
can now be placed in its holder on
the right of the unit. Alternatively,
you can switch the device to
standby by pressing and holding the
button on the hand piece or by
pressing the button on the foot
switch.
We recommend you disconnect the
device from the mains power supply
if is not going to be used for a while.
This will save electricity. The mains
plug must also be removed when it
comes to retiring the device.
11