GE CleanSpeak GTD81ESPJMC Technical Service Manual page 15

5. Remove and swap the two cover caps and door
handle from the outer door:
A. Squeeze the tabs on the inside of the door
handle clips. Push the clips through the
outer door.
B. Squeeze the tabs on the inside of the
cover caps. Push the caps through the outer
door.
Inside of door
Cover cap
C. Push the door handle clips into the openings
on the opposite side of the outer door,
to the inside.
D. Push the cover caps into the openings on
the outer door where the handle used to be
installed.
Inside of door
Door handle clip
Door handle
Door handle
Door handle clip
Cover cap
– 15 –
6. With the cover caps and door handle in place,
mount the inner door back into the outer door
with the screws that were removed in step 4.
Make sure to mount the hinges on the side
opposite of the handle.
Inside screws
Edge
screws
7. Mount the assembled door on the two upper
left side hinge screws installed in step 2. Move
the hinge screws loosened in step 3 into the
lower left side screw holes. Tighten those screws
enough to hold the door but still allow a slight
adjustment. Close the door. Adjust the door so
there is equal gap on all sides. Carefully open
Door
8. Install the four plastic caps removed in step 1
into the four right side front panel holes.
NOTE: To return the door to the original setup, follow
these instructions, swapping "left" and "right".
When Finished
Plug the dryer back into an electrical outlet.
Door
hinge
screws
Inside screws
Handle
Hang door and
tighten screws