Communication - GE CleanSpeak GTD81ESPJMC Technical Service Manual

CleanSpeak This dryer can communicate with a
TM
compatible washer (one whose Owner's Manual
contains a CleanSpeak™ description) via a standard
Cat-5e Ethernet cable with RJ45 male connectors
(not included). This cable may be purchased
separately.
Connection points
will vary by model
Order on-line at GEApplianceParts.com today, 24
hours a day or by phone at 800.626.2002 during
normal business hours.
Part Number Accessory
DR07X10005 6' cable - CleanSpeak™

communication

PBX10W00Y0 Wi-Fi ConnectPlus module
Wi-Fi Connect Some CleanSpeak™ dryers will
be Wi-Fi connect enabled through the use of a
built in communication card. Some will require
a Wi-Fi ConnectPlus module (PBX10W00Y0) to
be compatible. This will allow the appliance to
communicate with a smartphone for remote
of the Cat-5e cable is not needed when connected
to Wi-Fi. If the cable is connected, the Wi-Fi will not
operate.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired
operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be determined by
the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
•
• Consult the dealer or an experienced radio/television technician for help.
Labelling
user's authority to operate the equipment.
Communication
At the end of the wash cycle, the washer sends a
signal to the dryer to indicate a preferred dry cycle.
When the dryer becomes idle ("End" display times
out - or- the door is opened) "CYCLE" will scroll
across its cycle time display, its current cycle knob
recommended cycle LED will blink. If "CYCLE" times
out, pressing Power will refresh it and the LEDs. If
the dryer cycle knob is turned , the solid LED will
move accordingly. Pressing the dryer Start will
started.
NOTE: CleanSpeak™ CYCLE times out after 5
minutes. Pressing the power button will refresh
CYCLE and the LEDs no matter how long it has been
timed out.
Please visit www.GEAppliances.com/connect to
learn more about connected appliance features, to
learn what connected appliance app's will work with
a smartphone
Wi-Fi Connectivity: For assistance with the
appliance or the ConnectPlus network connectivity,
please call 800-GE-CARES.
– 13 –