Ignitor; Flame Detector - GE CleanSpeak GTD81ESPJMC Technical Service Manual

Ignitor

WARNING: Sharp edges may be exposed when
servicing the dryer. Use caution to avoid injury. Wear
Kevlar® gloves or equivalent protection.
The ignitor is located at the end of the burner
assembly in the combustion chamber opening and
has a maximum rating of 4 amps. The ignitor has an
The ignitor is attached to the gas valve bracket
with a Phillips head screw. To access the ignitor, it is
necessary to remove the burner assembly. (See the
Gas Valve Removal section in this guide and follow
steps 1 through 7.)
Gas Valve Bracket
NOTE: When installing the ignitor, make sure the
ignitor wiring harness is routed through the opening
in the burner bracket.
Harness Opening
CAUTION: The ignitor is very fragile. To prevent
breaking the ignitor, care must be taken when
installing the burner assembly.
Ignitor Harness
– 31 –

Flame Detector

the combustion chamber.
Flame Detector Removal
1. Remove the front bulkhead. (See Front Bulkhead
Removal in this guide.)
2.
detector.
3.
bottom.
Tab
NOTE: Upon reassembly, ensure the tab at the
located on the combustion chamber.