Table of Contents
Advertisement
"
Procedure
To install the FrameSaver SLV 9580 DSU in a standard rack:
9580-A2-GZ40-10
1. Determine the general position of the FrameSaver SLV 9580 DSU in the
rack. Hold one of the mounting brackets in that position and align it so that
the notches in the keyed holes of the bracket line up precisely with holes in
the rail.
2. Mark the holes in the rail where the two machine screws will go. Then mark
the opposite rail in the same positions.
3. If the rack has threaded holes, go to Step 4. If the rack does not have
threaded holes, fit self-retaining nuts over the rails at the marked holes.
4. Using a large Phillips screwdriver, put machine screws at the two bottom
screw positions you marked. Leave the screws loose enough that the
mounting brackets can slide over them.
June 1999
98-16023
3
Advertisement
Table of Contents
