Advertisement
Removing and Replacing the Memory Module
To remove and replace a memory module:
1.
2.
Figure 5
1
3.
Figure 6
1
4.
5.
6.
78-13711-03
Place the module face up on a flat antistatic surface.
Locate the SO-RIMM connector on the rear of the module. See Figure 5.
Memory Module Location
1
Memory module
Slightly extend the locking tabs on both sides of the memory module to release it. Gently pull the
module out of the connector. See Figure 6.
Memory Replacement
1
SO-RIMM connector tab
Align the replacement memory module so that the row of gold contacts on the memory module are
facing the row of gold pins inside the connector.
Insert the memory module into the connector at approximately a 30 degree angle (see Figure 6) and,
with gentle pressure, push the module into the connector until the module fits snugly against the
back of the connector. At this point, the module is still at an angle above the locking tabs.
Gently push straight down on the edges of the module until the tabs lock it into place.
Cisco 11500 Series Content Services Switch Switch Control Module Reference
5
Advertisement
