Advertisement
6.
Figure 3
1
2
1
7.
Figure 4
1
Note
The replacement SCM contains a 144 MB Small Outline RamBus Inline Memory Module
(SO-RIMM). If your failed module has a 288 MB SO-RIMM, you must remove its SO-RIMM, and
place it in the replacement SCM. See
document.
Installing the SCM
To install an SCM (refer to the previous illustrations):
1.
2.
3.
78-13711-03
Remove the SFP GBICs from the SCM. Press the ejectors on the SFP GBICs. Slide them out of the
module and set them aside. See
Ejecting the SFP GBIC from the SCM
MA NA GE ME
NT
10 BA SE -T
LIN K/A CT
STA TU S
DU PLE X
GE 1
LIN K
GE 2
GE 2
LIN K
PC MC IA
SLO T 1
3
SLO T 0
CO NS OL E
1
SFP GBIC ejector
Remove the flash or hard disks from the SCM. Press the ejectors to the right of the disks. Slide them
out of the module and set them aside. See
Ejecting the Disk from the SCM
MA NA GE ME
NT
10 BA SE -T
LIN K/A CT
STA TU S
DU PLE X
GE 1
LIN K
GE 2
LIN K
PC MC IA
SLO T 1
1
2
3
SLO T 0
CO NS OL E
1
Disk ejector
Properly ground yourself prior to handling the module, as noted on the previous page .
If applicable, reinstall the memory module, SFP GBICs, and flash or hard disks in the SCM.
Locate the slot in the chassis for the SCM. SCMs are restricted to slots 1 and 2.
Cisco 11500 Series Content Services Switch Switch Control Module Reference
Figure
3.
Figure
4.
"Removing and Replacing the Memory Module"
later in this
3
Advertisement
