Download Print this page

Cisco CSS 11500 Reference page 2

Switch control module

Advertisement

Before you remove or install a module, make sure you properly ground yourself prior to handling the
Note
module. For example, wear an antistatic wrist strap (included in the kit with the module) and stick
the copper-tape end of the strap to an unpainted metal surface on the chassis. Make sure that the wrist
strap makes good contact with your skin .
Removing the SCM
Caution
You must power down the CSS to remove an SCM. If you remove a powered-on SCM from an
operational CSS, the CSS terminates all communications and reboots.
To remove an SCM:
1.
2.
3.
4.
Figure 2
5.
Cisco 11500 Series Content Services Switch Switch Control Module Reference
2
Locate the failed SCM (its Status LEDs will be off). See
If necessary, power down the CSS.
Remove all cables from the module.
With a Phillips screwdriver, remove the PCMCIA cover and then loosen the spring-loaded screws
on the front of the module faceplate. See
Removing the PCMCIA Cover from the SCM
MA NA GE ME
NT
10 BA SE -T
LIN K/A CT
ST AT US
DU PL EX
GE 1
PC MC IA
SL OT 1
SL OT 0
Extend both ejectors simultaneously to unseat the module connector from the backplane and slide
the module out of the slot.
Figure
2.
LIN K
GE 2
LIN K
CO NS OL E
Figure
1.
78-13711-03

Advertisement

loading