Siemens SIPART PS2 Compact Operating Instructions page 9

Magnet holder made of glass fiber reinforced polyester
1. Insert the plastic washer
④
2. Fix the magnet
④
magnet can now be rotated easily on the clamping
table ⑨.
3. Slide the tensioning ring
sure that the spring elements
⑤
hooks on the magnet ④ and that they engage. You
will now have more resistance when turning the
①
tensioning ring
⑬
4. Screw the NCS onto the mounting console
⑫
.
⑬
5. Once the NCS is mounted, the clearance of 3 mm between the top edge of the magnet
⑩
mounting console
Procedure for part-turn actuators with manufacturer-specific interface
1. Steps 1 to 4 as above.
2. Set a clearance of 3 mm between the top edge of the magnet
the stub shaft accordingly, or insert washers underneath the NCS housing
Reference
For information on the scope of delivery, refer to chapter "Scope of delivery of NCS for part-turn actuators (Page 18)".
4.2 Mounting the NCS to a linear actuator up to 14 mm (0.55 inch)
Requirements
1. An EMC filter module in the positioner.
2. An NCS for linear actuators up to 14 mm (0.55 inch) 6DR4004-.N.20.
3. Linear actuator with interface to NAMUR. This installation must be carried out individually. Only a NAMUR mounting
bracket can be used as mounting base. The following figure shows the assembly with NAMUR mounting bracket.
Or
linear actuator without interface to NAMUR and individual mounting solution.
SIPART PS2 Non Contacting Sensor (NCS)
A5E00097485-09, 09/2014
⑥
into the magnet
onto the clamping table
①
over the magnet
③
are located above the
and magnet ④.
is set automatically.
Magnet holder made of anodized aluminum
④
. 1. Place the magnet
⑨
. The 2. Secure the magnet
connecting the two parts of the tensioning ring
the two hex socket head screws
④
can now be rotated easily on the clamping table ⑨.
. Make
3. Then tighten the two hex socket head screws
magnet
clamping table
⑩ ⑪
using the hex nut
④
and the top edge of the mounting console
④
onto the clamping table
④
to the clamping table
④
can then no longer be rotated on the
⑨
.
⑧
, the washer , and the hexagon socket screw
④
and the top edge of the
⑬
.
⑨
.
⑨
by
①
to
②
. The magnet ④
②
. The
⑩
. Extend
9