Siemens SIPART PS2 Compact Operating Instructions page 12

Procedure
1. Mount the clamping pieces
2. Slide the pick-up bracket
3. Set the necessary length.
4. Tighten the screws so that you can still shift the pick-up bracket
5. Set the center of the pin
⑤
lever . The actuating distance in mm will be displayed on successful initialization if you set the same value at
parameter "3.YWAY" when commissioning the system.
⑤
6. Slide the lever onto the shaft
⑤
7. Secure the lever
①
8. Mount the bracket
– Two hexagonal screws
⑨
– Spring washer
⑩
– Washer
⑰
– Hexagonal nut
The selection of the row of holes depends on the yoke width of the actuator. Make sure that the dog pin
②
the pick-up bracket
the clamping pieces.
9. Place the NCS assembly kit with the mounting bracket
②
the pick-up bracket
10. Tighten the pick-up bracket
11. Prepare the assembly parts for the relevant actuator type for installation:
– For mounting on yoke with fin: hexagonal screw
– For mounting on a yoke with plane surface: Four hexagonal screw
– For actuator with columns: Two U brackets
12. Mount the NCS assembly kit to the yoke using the assembly parts that you prepared.
Note
Observe the height
Adjust the height of the NCS assembly kit so that the lever position is in line horizontally with the stroke center. Use the
lever scale on the actuator for orientation. If a symmetrical assembly is not possible, you must always ensure that the
lever is in horizontal position within the range of the stroke.
Reference
For information on the scope of delivery, refer to chapter "Auto-Hotspot".
See also
Scope of delivery of NCS for linear actuators > 14 mm (0.55 inch) . (Page 19)
12
③
to the actuator spindle using the hexagonal screw
②
into the milled recesses of the clamping pieces.
④
to the stroke range value specified on the actuator, or to the next higher scaling value of the
⑱
up to the mechanical stop.
using the hex socket head screw
to the NCS mounting kit using:
⑧
as close as possible to the spindle over the complete stroke range. The dog pin must not touch
.
②
.
②
.
⑲
.
①
onto the actuator. Ensure that the dog pin
⑦ ⑩
, washer and spring washer
⑦
⑥
, four hexagonal screw
⑭
and spring washers
⑨
.
⑩
with washer and spring washer
⑰ ⑩
with washer and spring washer
SIPART PS2 Non Contacting Sensor (NCS)
A5E00097485-09, 09/2014
⑬
.
④
engages in
④
is guided inside
⑨
.
⑨
.