Table of Contents
Advertisement
Cleaning the water outlet
hose at the siphon
If the water outlet hose at the siphon
is dirty or the detergent solution is
not being pumped out, you must
clean these.
Switch off the appliance.
1.
Disconnect the appliance's mains
2.
plug from the power supply.
Loosen the hose clamp and care-
3.
fully remove the water outlet hose.
Residual water may leak out.
Clean the water outlet hose and si-
4.
phon connecting piece.
Reattach the water outlet hose and
5.
secure the connection point using
the hose clamp.
Cleaning and servicing en
Cleaning the water inlet filter
Clean the filter in the water inlet in
the event of blockages or if the water
pressure is too low.
Emptying the water inlet hose
In order to clean the filter, first empty
the water inlet hose.
Turn off the tap.
1.
Set a programme, except for
2.
Rinse, Spin or Drain.
Start the programme and leave it
3.
to run for approx. 40 seconds.
Switch off the appliance.
4.
Disconnect the appliance's mains
5.
plug from the power supply.
Cleaning the filter on the tap
Note: Please read the safety informa-
tion → Page 4 to ensure that you use
the appliance safely.
Requirement: The water inlet hose is
empty.
Remove the water inlet hose from
1.
the tap.
www.devicemanuals.eu/
55
Advertisement
Table of Contents
