9) Then iron over a piece of scrap fabric to remove any production
residues that may remain on the ironing sole 8 .
10)
Press the steam switch
The steam discharge then stops .
Filling the water tank
1) Place the iron on a level surface .
2) Open the cover on the water tank 1 filler opening .
3) Fill the measuring cup w up to the MAX marking with tap water
and fill this water into the water tank .
4) Close the cover on the water tank 1 filler opening .
5) Raise the iron vertically . You can read off the maximum water
level at the inspection openings 2 .
■
12
│
GB │ IE │ NI │ CY
3 again so that it re-engages .
SDBR 420 A1