Safety Instructions - SPIT SD 160 Operator's Manual And Maintenance Instructions

SAFETY INSTRUCTIONS

Safe use of the tool is only possible if the user had studied the instruction
manual and safety instructions completely and is strictly following the
instructions contained therein.
Additionally, the general safety instructions of the leaflet supplied with the tool
must be observed. Prior to the first use, the user should absolve a practical
training.
If the mains cable gets damaged or cut during the use, do not touch it, but instantly pull
the plug out of the socket. Never use the tool with damaged mains cable.
Prior to drilling in walls and ceilings, check them for hidden cables, gas and water pipes
and other media.
Check the working area, e.g. using a metal detector.
Prior to the start of your work, consult a statics specialist to determine the exact drilling
position.
If drilling through ceilings, secure the place below, because the may fall downward.
The tool must neither be wet nor used in humid environment.
► Do not use the tool in an environment with danger of explosion.
► Do not use the tool standing on a ladder.
► Do not drill into asbestos-containing materials.
► Do not carry the tool at its cable, and always check the tool, cable and plug before
use. Have damages only repaired by specialists. Insert the plug into the socket only
when the tool switch is off.
► Modifications of the tool are prohibited.
► Unplug the tool and make sure that the switch is off if the tool is not under
supervision, e.g. during preparation and take-down works, at power failures, for
insertion or mounting accessories.
► Unplug the tool if is stops for any reason. So you avoid sudden starts in unattended
condition.
► Do not use the tool it its shell, switch, cable or plug are damaged.
► Always lead the mains and extension cables as well as the dedusting hose from
the tool to the back.
► Electrical tools have to be inspected visually by a specialist in regular intervals.
► The tool may be used only in two-hand operation or with the drill rig.
► Keep the handles dry, clean, and free of oil and grease.
► Do not touch rotating parts.
► Persons under 16 years are not allowed to use the tool.
► During use, the user and other persons standing nearby have to wear suitable
goggles, helmets, ear protectors, dust mask, protective cloves and boots.
► During manual operation, always hold the tool with both hands and be fall-safe.
Consider the tool's reaction torque in case of blocking.
► Always work with concentration. Always work in a carefully considered way and do
not use the tool if you are lacking consideration.
► During manual operation, work with a special circumspection when dry drilling with
dimensions between 100 and 200 mm !
GB
2