Removing Transit Support Screws; Connections - Greiner Bio-One CheckScanner 2.0 Instructions For Use Manual

14.1 Removing the transit support screws
Your Power for Health
1
Open the CheckScanner™ 2.0 lid.
2
Unscrew the two red butterfl y screws in
the direction indicated and remove them.
3
Unpack the two plastic sealing plugs.
4
Push the two plastic sealing plugs into
the holes until they are securely fi xed in
position.
14.2

Connections

The following guideline outlines the connections required for the trouble-free operation of the
CheckScanner™ 2.0 system. For the sake of completeness, connections to both the instrument
and the computer are listed.
Instrument Connections
The instrument is connected to the laboratory mains power socket via the specifi c external power
supply (AC adapter) included in the sales package. Use solely this specifi c external power supply!
The mains power must provide grounding. If the mains power does not provide grounding, the
instrument must be grounded via the optional earth, which is located on the right side of the
Greiner Bio-One GmbH
instrument backside. Switch off the instrument. Connect the 24 V outlet cable of the external power
Maybachstr. 2
supply to the corresponding connector at the rear panel of the instrument.
72636 Frickenhausen
Germany
Made in Germany
CheckScanner™ 2.0 - Instructions for Use
Revision: BQ-686-01 /March 2017
Before starting the CheckScanner™ 2.0 installation the transit support screws need to be
removed. Please follow the instructions below.
Keep the red butterfl y screws in
!
case the instrument needs to be
transported or returned.
862 070
13