Displaying the Status Screens
You can use the status screens to check the camera's various settings. You can also output the status screens
to an external monitor.
1 Set an assignable button to [Status] (A 119).
2 Press the assignable button to open the status screens.
• The status screen most recently displayed will appear unless you turned off the camera or changed the
operating mode.
3 Scroll through the status screens to check the desired settings.
• Navigate the status screens in the same way you do the setup menus.
4 Press the assignable button again or select [X CLOSE] to close the status screens.
• You can also press the MENU button to close the status screens and open the menu instead.
To skip directly to the page of a specific status screen:
[
Gamma/Color Space/Range]
[/] (custom picture file in use)
[v Camera Setup]
[
Assignable Buttons]
[
Gamma/Color Space/Range] status screens (CAMERA mode only)
1
2
3
4
1 Gamma curve, color space (A 126) and range
used for recording clips
[CFexpress]: Primary clips on the CFexpress card
[SD Card]: Proxy clips on the SD card
2 Gamma curve, color space (A 126, 147) and
range (A 146) used for video outputs/monitoring
devices
[SDI OUT], [MON.], [HDMI]: Video output from the
respective terminal ([HDMI] indicates the HDMI
OUT terminal)
[VIDEO]: LCD screen
[EVF-V50]: Optional viewfinder
[IP Strm. (8 bit)]: IP streaming signal (A 170)
(A 191)
[¡ Audio Setup]
(A 192)
[B System Setup]
(A 193)
[Æ Recording/Media Setup]
(A 194)
[
Network Settings]
3 Gain for HDR-to-SDR conversion (A 148)
4 HLG color quality (A 126, 148)
Displaying the Status Screens
(A 195)
(A 196)
(A 197)
(A 198)
191