Warning - J. A. Roby ATMOSPHERE Owner's Manual

Before installing, please take a few minutes to read this handbook. Keep it in a sure
place and easily reachable for future references. If this appliance is not properly installed,
it could cause fire damages to the property, injuries and death. To reduce fire hazards,
follow instructions contained in this handbook.
Contact an official inspector (ex: a fireman) or your insurance company for installation
permit. Always respect the provincial and municipal building codes of your region.
Do not connect this appliance to a chimney that already serves for another wood stove.
The existing chimney should be well inspected before any installation. In doubt,
consult a specialist.
Never use a non-isolated exterior conduct or a single pipe as an exterior exit.
Minimum clearances found in this manual must be observed.
Install all firebricks before lighting the stove (if it is not already done).
CAUTION :
CHILDREN, CLOTHING AND FURNITURE AVAY FROM STOVE.
CONTACT MAY CAUSE SKIN BURNS. SEE NAMEPLATE AND
INSTRUCTIONS
Never let the appliance without supervision when the door is open.
Always close the doors after the lighting period.
Operate only with doors closed
Do not use chemical products or other liquid to light the fire.
Do not burn waste or inflammable fluids like gas, naphtha or motor oil.
Do not overfire. If the heater or chimney connector glows, you are overfiring.
(See manual)
Always keep combustible material (clothes, furniture, wood, matches, plastics, etc...)
at a minimal distance of 91,5 cm (3 feet) from the appliance.
This appliance is certified to burn cordwood only. Do not use any other
combustible.
Never use a non-isolated exterior duct or a pipe to evacuate chimney smoke.
Do not install in a mobile house.
Do not use chemicals or fluids to light the fire. Never burn flammable waste or fluids
such as gasoline, naphtha or engine oil
Wood should not be stocked within the recommended minimums clearances or in the
necessary space for the loading and the ashes evacuation.

WARNING

HOT WHILE IN OPERATION, DO NOT TOUCH. KEEP
3