Reset; Set Connection Type; Ethernet; Wifi - ETC ETCpad Setup Manual

ETC Setup Guide
ETCpad

Reset

This display allows you to either reset the network settings or restore the device to factory settings.

Set Connection Type

This options allows you to set the network connection type to either ethernet or WiFi.
Note:

Ethernet

In this display, you can configure the device to connect via ethernet by using the network adapter.
The IP settings can be set to either Static (you provide the IP address) or DHCP (IP address is automatically
obtained from a DHCP server).
If Static is selected, you will need to provide the IP Address, Subnet Mask, and Default Gateway.

WiFi

In this display, you can select an available WiFi network to connect to when WiFi is turned on.
Tapping an available network will give you the options to connect to it, forget the network, or cancel out
of this option.
If you tap a connected network, you will have the options to forget the network or cancel out of this
option.

Add Hidden Network

In this display, you can add a WiFi network with a non-broadcasting (hidden) SSID (System Set Identifier).
To add, you will need to enter the SSID, Security type, and IP Settings. The IP settings can be set to either
Static (you provide the IP address) or DHCP (IP address is automatically obtained from a DHCP server). Once
entered, tap Add Network to create.

Accessories

The following accessories are available for use with your ETCpad:
• Network Adapter
• USB Hub
• Hand Strap
• Shoulder Strap
• Replacement Batteries
• VESA Base
• Office Base
• Stylus
• MultiTablet Charger (Charges up to 6 tablets)
Note:
ETCpad
You can only select one connection type at a time.
For a list of which accessories ship with ETCpad, please see
Page 5 of 8
Overview on page 1.
ETC