Clock; Operating The Radio; Aux / Usb / Ipod Mode; Setting The Time - Fiat Spider 124 Owner's Handbook Manual

AF (Alternative Frequency);
REG (Regional Programme);
ALC (Automatic volume adjustment);
BASS (Low pitch sound);
TREB (Treble sound);
FADE (Front/back volume balance);
BAL (Left/right volume balance);
BEEP (Audio operation sound);
12Hr < > 24Hr (12 Hr/24 Hr time
adjustment).

CLOCK

Setting the time

The clock can be set at any time when
the ignition is switched to ACC or ON.
To adjust the time, press the clock
button FM/ AM for about 2 seconds
until a beep is heard. The clock's
current time will flash.
Time adjustment
To adjust the time, press the
hour/minute set button
while the clock's current time is
flashing.
The hours advance while the hour set
button is pressed. The minutes
advance while the minute
button is pressed.
Press the clock button FM/ AM again
to start the clock.
190

OPERATING THE RADIO

Radio ON: press a band selector
button FM/AM to turn the radio on.
Band selection: press the band
selector button FM/ AM to switch the
bands as follows: M1–FM2–MW/LW
Manual tuning: select the station by
pressing the tuning button
lightly.
Seek tuning: press tuning button
/ . The search stops when a
station is found.
Scan tuning: press and hold the scan
button MEDIA to automatically sample
strong stations. Scanning stops at each
station for about 5 seconds. To hold a
station, press and hold the scan button
MEDIA again during this interval.
Preset channel tuning
The 6 preset channels can be used to
store 6 MW/LW and 12 FM stations.
/
To set a channel first select MW/LW,
FM1, or FM2. Tune to the desired
station.
Press a channel preset button for
about 2 seconds until a beep is heard.
set
The preset channel number or station
frequency will be displayed. The station
is now held in the memory.
Repeat this operation for the other
stations and bands you want to store.
To tune one in the memory, select
MW/LW, FM1, or FM2 and then press
its channel preset button. The station
frequency or the channel number will be
displayed.

AUX / USB / iPod MODE

Auxiliary jack / USB port
Audio can be heard from the vehicle's
/
speakers by connecting a commercially
available portable audio unit to the
auxiliary jack. A commercially-available,
non-impedance (3.5 Ø) stereo mini plug
lead is required. In addition, audio can
be played from the vehicle audio device
by connecting a USB device or an iPod
to the USB port.
How to use AUX mode
Switch the ignition to ACC or ON, press
the power/volume dial to turn the audio
system on and press the MEDIA
button of the audio unit to change to
the AUX mode.
How to use USB mode
This unit does not support a USB
3.0 device. In addition, other devices
may not be supported depending on
the model or OS version.
Playback
Switch the ignition to ACC or ON, press
the power/volume dial to turn the audio
system on and press the MEDIA