Tip
•
You can check the status of the wired or wireless
connection of this product (see "Adjust settings" >
"Network Setup" >[View Network Settings] or [View
Wireless Settings]).
Use Philips EasyLink
This product supports Philips EasyLink which uses the
HDMI CEC (Consumer Electronics Control) protocol.
You can use one single remote control to control
EasyLink-compliant devices that are connected
through HDMI connectors.
Note
•
To enable the EasyLink feature, you must turn on the
HDMI CEC operations on the TV and on other devices
connected to TV. Refer to the TVs/devices manual for
details.
One-touch play
1
Press
(standby) to turn on this product.
»
The TV (if the TV supports one-touch play)
automatically turns on and switches to the
correct video-in channel.
»
If a disc is loaded in this product, disc play
automatically starts.
One-touch standby
1
Press and hold
(standby) for more than 3
seconds.
»
All the connected devices (if the device
supports one-touch standby) automatically
switch to standby.
Note
•
Philips does not guarantee interoperability with other
HDMI CEC devices.
5 Play
Play a disc
Caution
•
Do not place any objects other than discs into the disc
compartment.
1
Press
to open the disc compartment.
2
Insert a disc with its label facing up.
3
Press
to close the disc compartment and
start disc play.
•
To view disc play, turn on the TV to the
video input.
•
To stop disc play, press
Note
•
Check disc/file formats supported (see "Your product" >
"Playable media").
•
If the password entry menu is displayed, enter the
password before you can play the locked or restricted
disc (see "Adjust settings" > "Preference Setup" >
[Parental Control] ).
•
If you pause or stop a disc, the screen saver appears after
10 minutes of inactivity. To deactivate the screen saver,
press any button.
•
After you pause or stop a disc and no button is pressed
within 30 minutes, this product automatically switches
to standby.
Play from a USB device
Play or view media files on the following USB devices:
•
flash drive
•
memory card reader
•
HDD (This product can detect only a portable
hard disc drive with USB power peak current
no more than 500mA.)
1
Connect a USB device to the
on the front panel of this product.
2
Press
, and select [browse USB], and press
OK.
»
A contents menu is displayed.
.
(USB) jack
EN
15