Table of Contents
Advertisement
SA-AK33 1GCP
10.12.4. Replacement for the motor ass'y
Step 1 Install the belt temporarily.
NOTE:
Take care not apply the grease to the belt.
Step 2 Upset the CD loading unit.
Step 3 Remove 3 screws.
Step 4 Unsolder the plunger terminals (2 points).
Step 5 Unsolder the motor terminals (2 points).
10.13. Replacement for the pinch roller ass'y and head block
· Follow the (Step 1) - (Step 2) of Item 10.3 - Disassembly of Top Cabinet
· Follow the (Step 1) - (Step 6) of Item 10.4 - Disassembly of CD Lid
· Follow the (Step 1) - (Step 3) of Item 10.6 - Disassembly of CD Mechanism Unit
· Follow the (Step 1) - (Step 3) of Item 10.10 - Disassembly of Front Panel Unit
· Follow the (Step 1) - (Step 5) of Item 10.11 - Disassembly of Deck Mechanism Unit
* The mechanism as shown below is for DECK1. For DECK
2, perform the same procedures.
Step 6 Release the 2 claws (A), and then remove the Motor
P.C.B.
Step 7 Release the claw (B), and then remove the motor ass'y.
[Notice for motor ass'y installation]
1. Locate the name plate of motor to the traverse ass'y.
2. Align the hole of motor with the ribs.
32
Advertisement
Table of Contents
