Zcom AS220V2 Quick Start Manual page 6

AS220V2
Note: Switching from DHCP to assign a static IP address or DNS and L2 discovery mode
to the access point, please refer to the user manual for more information.
https://www.zcom.com.tw/index/downloads?keyword=&meterial_type=25
If the access point cannot connect to the WLC by DHCP broadcast, please refer to the following
optional settings.
Optional: Set up a static IP address
Note: The following procedure assumes that Windows 10 is the operating system.
Procedures for other operating systems are similar.
Step 1. On your computer, configure your network adapter from the "Local Area Connection
"settings as follows:
˙ StartControl PanelNetwork & InternetChange Adapter OptionsEthernet
Step 2. Edit the TCP/IPv4 address setting as follows:
˙ PropertiesInternet Protocol Version 4 (TCP/IPv4)
Step 3. Select Use the following IP address
"
˙ IP address: 192.168.1.168 (or any available address in the 192.168.1.x network, except
192.168.1.1)
˙ Subnet mask: 255.255.255.0
Leave the "Default gateway" and "DNS server" fields empty.
Step 4. Click "OK" to save your changes.
Login into the access point
Step 5. Launch a Web browser; type default URL 192.168.1.1 to connect to the access point.
When a security alert dialog box appears, click OK/Yes to proceed.
Step 6. When login page appears, enter the following: Username: root/Password: password
Step 7. Click login.
Customizing the Wireless Settings
On the Web interface menu, Select StatusGeneral in the menu bar. Check your switchmod item
to select "Connect with via IP", and setup your WLC IP address on "Wireless Switch Address 1".
Note: IP address of WLC needs to be assigned (ex. 192.168.1.228) while on operation.
Note: If you need a standalone access point, please change to FAP mode.
2x2 Dual Band 802.11ac Wave 2 Indoor Access Point
and make the following entries:
"
QSG
5