Table of Contents
Advertisement
1.
WARNINGS AND INSTALLATION TIPS
This manual contains important information concerning personal safety. An incorrect installation or an improper use may lead to
severe injuries. Read carefully and store for future use.
Pay particular attention to this symbol.
Switch the power OFF before any operation.
Double check the electrical grounding and fit a disconnection device as well as overcurrent protection.
Keep the remote controls away from children.
•
Use <HAR> wires/cables, minimum section 2 mm².
•
Do not alter the original internal wiring.
•
If power cut occurs, turn the power off and only then proceed to open and release the system.
•
Give any start command only if the system is visible.
•
Do not open the barrier housing when the system is operating.
•
Do not allow children to play within the system area.
•
Fixed start commands must be positioned at a minimum height of 1,5 m from ground.
The installation of automatic doors and gates must comply with the Machine Directive 2006/42/CE, in particular with EN 12453
provision.
The definitive connection to the power supply, as well as testing and starting shall be performed by qualified personnel, who will be
held to check risks and ensure the system complies with the current regulations.
This product has been designed only for its intended use. Any other use could affect the integrity and safety of the product, therefore
has to be considered prohibited.
Use only original spare parts. No alteration on the system has to be carried out. Proteco Srl will not respond in case of using additional
and/or fake spares.
Automatic barriers are not suitable for pedestrian clearance.
BARRY is designed for vehicular clearance only.
Manufacturer:
PROTECO S.r.l.
Address:
Via Neive, 77 – 12050 Castagnito (CN) – ITALIA
Declares
The Product:
BARRY Automatic Road Barrier
Type:
BARRY 230V, BARRY DC 24V
Complies with the essential requirements of EEC Directives:
2014/35/UE Low Voltage Directive
2014/30/UE Electromagnetic Compatibility Directive
2014/53/UE RED Directive
RoHS2 2011/65/CE
It complies, where applicable, with the following provisions:
EN 61000-6-2,
EN 61000-6-4
EN 61000-3-2,
EN 61000-3-3
EN 12453
EN 60335-1,
EN 60335-2-103
The manufacturer declares that the start-up of the machinery is not permitted unless the machine, in which the product is incorporated or of which
is becoming a component, has been identified and declared as conformed to 2006/42/EC Machinery Directive.
Castagnito, 2018 November 8th
1
CE
COMPLIANCE DECLARATION
Marco Gallo
CEO
Advertisement
Table of Contents
