Changing The Program; Erasing The Program - Philips MC-90 Manual

5
Press YES to store the selection.
Press NO will clear the current track selection
and back to the previous track in the program.
6
Repeat steps 3–5 to store other discs and
tracks.
7
To end programming, press Ç once .
stays and the program mode remains
PROG
active.
The total number of tracks programmed and
the total playing time are displayed.
8
To start program play, pressÉ Å .
"PLAY PROGRAM" is displayed.
Notes:
– If the total programmed playing time is more
than 320 minutes, "--:--" is displayed.
– If you attempt to program more than 99 tracks,
"PROGRAM FULL" is displayed.
– In program mode, pressing the CD DIRECT
1/2/3 buttons on the remote control will play the
selected disc and the stored program will be
ignored temporarily. The program will resume
when playback of the selected disc ends.
– During programming, if no key is pressed within
20 seconds, the system will exit the Program mode
automatically.
To review the program
Stop playback and adjust JOG CONTROL (or
pressí or ë on the remote control).
To exit review mode, press Ç.

Changing the program

1
Press PROG.
2
Press à or á to move to the track number
you want to change.
3
To remove the track from the program;
Refer to "Erasing the program".
To insert a new track;
Adjust JOG CONTROL to select a new track
and press YES to confirm.
The new track will be inserted in front of the
selected track.
pg 001-039/MC90/37-Eng
CD Changer/Recorder Operations

Erasing the program

To erase a track
1
Stop playback and press CD 1•2•3 or CDR to
select a disc.
2
Press PROG.
3
Press à or á to select a track number.
4
Press NO to erase the selected track from the
program.
"CLEARED" is displayed.
The following program tracks' numbers are
decreased by one.
To erase the entire program
1
Stop playback and press NO.
"CLEAR PROG?" is displayed.
2
Press YES to erase the entire program.
PROG
displayed.
Note:
– The program will be erased when the system
switched to standby mode, disconnected from the
power supply or when the disc tray is opened.
23
disappears and "PROG CLEARED" is
3139 115 20961
1/30/02, 8:59 AM
23