Xplore XSLATE R12 User Manual page 7

BATTERY MUST ONLY BE CARRIED OUT IN A NON-HAZERDOUS AREA USING THE SUPPLIED AC
ADAPTOR. The definition of hazardous areas can be found in Standard EN 60079-10.
WARNING: When operating the tablet in a known explosive environment do not remove or replace the
battery while the circuit is live. Before removing the battery verify that the area is known to be free of
ignitable concentrations of flammable substances. EXPLOSION HAZARD – DO NOT DISCONNECT
WHILE CIRCUIT IS LIVE UNLESS AREA IS KNOWN TO BE NON-HAZERDOUS. AVERISSEMENT –
RISQUE D'EXPLOSION. NE PAS DÉBRANCHER TANT QUE LE CIRCUIT EST SOUS TENSION, À MOINS
QU'IL NE S'AGISSE D'UN EMPLACEMENT NON DANGEREUX.
WARNING: EXPLOSION HAZARD - DO NOT REPLACE THE BATTERY UNLESS POWER HAS BEEN
SWITCHED OFF ANDTHE AREA IS KNOWN TO BE NON-HAZARDOUS; AVERTISSEMENT - RISQUE
D'EXPLOSION - COUPER LE COURANT OU S'ASSURER QUE L'EMPLACEMENT EST DESIGNE NON
DANGEREUX AVANT DE REPLACER LE BATTERY.
WARNING: EXPLOSION HAZARD - SUBSTITUTION OF COMPONENTS MAY IMPAIR SUITABILITY
FOR CLASS I, DIVISION 2; AVERTISSEMENT - RISQUE D'EXPLOSION - LA SUBSTITUTIOND E
COMPOSANTSP EUTR ENDRE CE MATERIEL INACCEPTABLE POUR LES EMPLACEMENTS DE
CLASSE I, DIVISION 2;
WARNING: EXPLOSION HAZARD - DO NOT DISCONNECT EQUIPMENT UNLESS POWER HAS BEEN
SWITCHED OFF AND THE AREA IS KNOWN TO BE NON-HAZARDOUS. AVERTISSEMENT - RISQUE
D'EXPLOSION - AVANT DE DECONNECTER L'EQUIPEMENT, COUPER LE COURANT OU S'ASSURER
QUE L'EMPLACEMENT EST DESIGNE NON DANGEREUX.
WARNING: Do not use any dock or any other accessory or attachment that is not
manufactured or supplied by Xplore or an authorized Xplore accessories supplier. Use of any
accessory or attachment that is not supplied or approved for use with the tablet by Xplore is
not permitted because it may cause hazards.
Only use the approved XSLATE R12 AC adapter
shipped with your tablet. (P/N 0432-03JR0MC) Do NOT use any other adapter because it may cause
intermittent contact and not charge correctly.
Operate the tablet only from Xplore approved power sources. Route power supply cords so that they
are not likely to be walked on or pinched by items placed upon or against them. Pay particular attention
to cords at plugs and convenience receptacles, and at the point where cords exit from the tablet or its
dock. Do not overload wall outlets, extension cords, or integral convenience receptacles because this
can cause fire or electric shock.
Unplug the tablet and refer the tablet and dock for service to qualified service personnel if any of the
following conditions occur:
• The power supply cord or plug is damaged.
• The tablet does not operate normally when you follow the instructions in this book.
• The tablet exhibits a distinct change in performance.
6