Philips LX9000R/25S User Manual page 65

Problem
COPY PROT is displayed
Does not record
Timer recording does not work
Wrong TV channel was recorded after
you programmed a recording using
®
ShowView system
Switch off; timer recording flashes on
the TV screen
Insert recordable disc indication
Disc locked is indicated briefly
Memory full indication after pressing
TIMER on the remote control
Data error indication
Collision indication
Solution
– The video source (DVD, video tape, ...) from which you want to record,
is copy protected. Recording is not possible.
– The desired TV channel for recording is not stored or a wrong programme
number (channel number) has been selected. Check the TV channels stored.
– The inserted disc is write protected. Remove the write protection or load
another non write protected disc.
– An already finalised DVD+R disc has been inserted. Replace it by an
unfinalised DVD+R disc.
– Make sure the time/date is programmed correctly.
– Make sure all information in the timer block is programmed correctly.
– The inserted disc is write protected. Remove the write protection or load
another non write protected disc.
– Make sure no finalised DVD+R disc has been inserted.
– Make sure the time for VPS/PDC has been entered exactly to the minute.
– Check the aerial connection.
1 ®
– Enter the ShowView programming number of the desired TV channel.
2
Press OK to confirm.
3
Check the programme number entered in the line Prog.. If it does not
correspond to the desired TV channel, select the input field and change
the programme number.
4
Press OK to confirm.
– The DVD recorder system is switched on a few minutes before a timer
recording starts. However, a timer recording only works if the
DVD recorder system is switched off. Press 2 to switch the
DVD recorder system off.
– Make sure a recordable DVD+R or DVD+RW disc is inserted.
– A write protected disc has been inserted. Cancel the write protection (see
"Activating or deactivating the write protection") or load a disc that is not
write protected.
– All timer blocks are already programmed. No further recordings can be
programmed unless an existing timer block is cleared.
– The data for the recording could not be transferred. Check the date, start
time and end time of the timer recording.
– The data for 2 timer recordings overlap. Change the data for one
recording or delete one of the timer recordings. If you ignore the
indication, the timer recording with the earlier start time will be
recorded first.The start of the second recording will be missing.
Troubleshooting
65