Obtaining The Correct Firmware Patch - HP D Series Upgrade Manual

D Class System Memory Upgrade
Troubleshooting Memory Configuration Error Symptoms
PDC Code Revision
Handler (BCH). Perform the following steps to use the BCH for PDC revision
checking:
1. Log on as root, and enter reboot -r. This command will shutdown the
Operat ing System and reboot the system.
2. If autoboot is on, you will receive the following message:
"Process is starting autoboot process
To discontinue, press any key within 10 seconds"
At this point, press any key within 10 seconds to interrupt the boot process.
3. The Main Menu is displayed. At the Main Menu prompt, enter in .
4. The Information Menu is displayed. At the Information Menu prompt, enter fv .
The system will respond with the current firmware revision.
For Models D200/D210/D310, the revision should be 36.12 or later. If it is not, your
system will require a PDC update.
For other D2xx and 3xx models except Dx70, the revision should be 36.20 or later.
If it is not, your system will require a PDC update.
For Dx70 models, the revision should be 37.28 or later. If it is not, your system will
require a PDC update.

Obtaining the Correct Firmware Patch

The firmware patches for all HP 9000 Enterprise Server systems can obtained from
either the HPESC (HP Electronic Support Center) via the World Wide Web, or via
FTP.
1-32
You can verify the PDC revision using the Boot Console