Table of Contents
Advertisement
Installation, Features, & Functions
Application of Input Power
1. Using the provided power cord, insert the female end into the power input receptacle located at the
bottom of the instrument. Refer to Figure SU-15.
2. Plug the male end of the power cord into a wall outlet of the appropriate voltage. Input voltage must
not exceed the range listed in the Specifications section of this manual.
3. Set the ON / OFF switch to ON ( I ).
Disconnection of Input Power
At any time, the power switch can be set to OFF. The unit does not have a power down sequence.
To terminate operation of the ClearChart 4, press the ON / OFF switch to the OFF position (O).
Note: If the ClearChart 4P is intended to be OFF for an extended period of time, the ClearChart 4P
can be disconnected from power by detaching the power cord from the receptacle.
Note: Even though the system has a low power mode, it is recommended to shut the instrument off
at the end of the day.
13785-101 Rev. F
On/Off
Switch
Figure SU-15 Power Cord and On/Off Switch
(continued)
Power
Cord
15
Advertisement
Table of Contents
