Table of Contents
Advertisement
Installation, Features, & Functions
Articulating Wall Mount
Attaching the ClearChart 4P to the Mount
1. Align the half of the mount that was removed in the previous steps to the back of the ClearChart
4P, aligning it with the screw holes. Refer to Figure SU-10.
Screw
Holes
Note: There is a slot on the back of the mount. Be sure this slot remains
in the vertical position when aligning the mount to the back of the
ClearChart 4P. Refer to Figure SU-11.
2. Using the Thumb Screws, secure the mount to the ClearChart 4P by
hand-tightening the 4 screws into the outer screw holes on the back of
the case of the ClearChart 4P. Refer to Figure SU-10.
Note: The screws must make at least three full turns into the mounting hole
and fit snugly into place. Do not over tighten.
3. Slide the ClearChart 4P onto the mounting bracket that is already attached
to the wall, so the square slides into the slot on the mount. Refer to Figure
SU-12.
4. Secure the mount by tightening the two small flathead screws on either
side of the mount where the ClearChart 4P attached to the wall mount.
Refer to Figure SU-13.
Slide
Down
Attached to Wall
Figure SU-12 Attach ClearChart 4P to Wall Mount
13785-101 Rev. F
(continued)
Align Outer
Figure SU-10 Align Holes and Attach Mount
Attached to
ClearChart 4P
Attached
to Wall
Side
View
Holes
Figure SU-13 Securing Screws
(continued)
Install
Thumb Screws
Figure SU-11 Align
Slot Vertically
Securing
Screw
13
Advertisement
Table of Contents
