Advertisement
8E
The remaining tabs (Flash Loader, PIC Loader and Test) can
be left at their default settings.
Step 9
Final Configuration at the Site Controller (XFC/XRC)
With the WellTell-X host and the WellTell-IS client both installed and
configured, the last step is to configure the site controller (XFC/XRC at
the host end) for the LevelMaster application. There is no difference in
the configuration of the LevelMaster application due to the presence of
the WellTell products. LevelMaster is instantiated and configured as it
would be without the WellTell products.
With the system up and running, the WellTell-X host display looks similar
to Figure 11.
The antenna symbol is on. The "$" symbol is always active on the
WellTell-X or host server. The "-" is the system heart beat and blinks
continuously. The blink slows down whenever the radio is dead or not
connected. The "F3" in the upper right of the display denotes that this is
a host server (WellTell-X). The main area of the display scrolls through
several parameters: baud rate, temperature, channel, etc. For more
information on the display, refer to the appropriate appendix.
LCD Display and Annunciators
Figure 11 – WellTell-X (Host) Display
Figure 12 – LCD Display
11
Advertisement
