Description Of The Product; Installation And Electric Connections - Nice Moon MOTB Instructions And Warnings For Installation And Use

DESCRIPTION OF THE PRODUCT

2
AND DESTINATION OF USE
The MOTB digital selector is a device that permits to check and allow access to
places or services, exclusively to authorised staff.
AT TENTION! – Any use different to that described and in environmental
conditions different to those stated in this manual must be considered
improper and prohibited!
With MOTB it is possible to command an automation by entering one of the
previously-memorised numerical combinations from the keyboard.
It has a removable memory; this can be programmed (see chapter 4) also with
the aid of the Nice O-Box and MOU programming units.The MOTB communi-
cates with the devices present in the automation by means of the "Bluebus"
system. This allows to make the electric connections with the aid of only 2
wires, on which both the electrical input and the communication signals transit.
The electric connection is the parallel type and polarities do not have to be
respected. Every device connected to the control unit is recognised individually
during the learning phase thanks to the addressing of the electric jumper pres-
ent in the keyboard. Moreover, during the learning phase the command devices
are associated to the control unit by an unmistakable code, which guarantees
maximum safety in order to prevent fraudulent attempts to replace the device.
2 – English
INSTALLATION
3
AND ELECTRIC CONNECTIONS
3.1 - Preliminary checks before installation
Before performing installation, check the integrity of the product components,
the adequacy of the model chosen and the suitability of the environment des-
tined for installation:
• Check that all material to be used is in optimal state and suitable for the use
envisioned.
• Check that all conditions for use lie within the product limits of use (para-
graph 3.2)
• Check that all use parameters lie within the limits of the values stated in the
"Product technical features" chapter.
• Check that the place chosen for installation is compatible with the total clear-
ance of the product.
• Check that the surface chosen for the installation of the device is solid and
can guarantee stable fixing.
• Check that the device to be installed is placed in a position where it is pro-
tected from accidental blows.
3.2 - Limits of use for the product
• Check that the product is compatible with the control unit to which it must be
connected; refer to the attached yellow sheet.
• Do not install a number of devices in the plant that exceeds that supported by
the control unit (see respective instruction manual).

3.3 - Installation and electric connections

Before performing installation, establish the position in which the device will be
fixed and prepare the electric cables necessary for connection to the control
unit. To verify the type of cable to use, refer to the control unit instruction man-
ual (technical features of the cables).
For installation, proceed as described below and see fig. 1:
ATTENTION! – All connections must be made without the presence of the
electric power input.
01. Remove the front panel and loosen the 2 screws present;
02. Separate the base of the keyboard, paying attention not to damage the
protection gasket present;