Product Maintenance - Nice Moon MOTB Instructions And Warnings For Installation And Use

3 flashes + pause Closing
4 flashes + pause Partial open ("
5 flashes + pause Stop
6 flashes + pause Courtesy lamp
• Procedure for the " " command
01. Introduce a valid combination for the current command.
02. Press the " " key. The "L1" (fig. 3) flashes followed by a pause depending
on the control set (see Table 6)
03. Press the "P" key (fig. 3) to select the desired command
04. Press the key to confirm
• Procedure for the " " command
01. Introduce a valid combination for the current command.
02. Press the " " key. The "L1" (fig. 3) flashes followed by a pause depending
on the control set (see Table 6)
03. Press the "P" key (fig. 3) to select the desired command
04. Press the key to confirm
6.2 - Procedure for deleting data from the BM memory
This function can be used to delete all data contained in the keyboard BM
memory. Attention! – Every time the memory is deleted, keyboard addressing
from the control unit must take place (see respective manual instructions)..
Procedure for deleting the entire memory if programmed in
EASY mode or if programmed in PROFESSIONAL mode and
NOT if the password is known
01. Press and hold the "P" key (fig. 3); the "L1" led will stay on for 3 seconds
and then flash 3 times
02. Release the key during the 3rd flash
At the end of the procedure the "L1" LED emits a series of impulses and after a
few seconds, if the procedure has been performed correctly the keyboard
emits 3 acoustic tones (beeps) and flashes 5 times for confirmation.
At this point keyboard learning must take place by the control unit; it will then
be possible to program the keyboard in "EASY" and "PROFESSIONAL" modes.
" factory-setting)
7
WHAT TO DO IF... (troubleshooting)
• If the keyboard lighting flashes (2 flashes and pause): check that the
jumper is inserted correctly.
• If several keyboards are connected to the control unit and the lighting
starts to flash (3 flashes and pause) when a command is activated, but
the latter is not activated: check that the same addresses have not been
entered.
• If the keyboard does not emit any acoustic sound when entering a char-
acter: check that the BM memory is inserted correctly.
• If L1 LED flashes when a command is activated indicating that the latter
has been activated, but the control unit does not activate any operation:
check that the device learning phase has been performed correctly by the
control unit.
• If the device does not switch on: use a suitable instrument to check that
voltage is present (vdc) on the Bluebus.
• If the device switches on but does not function: check that the control
unit to which the keyboard is connected supports the bluebus connection for
the control devices.
• If a combination is entered incorrectly 3 times, the keyboard blocks and
emits an acoustic signal with regular intervals: the keyboard is released
automatically after 1 minute.
• If the automation does not respond to the activation of a command and
the keyboard green lighting is permanently on: an automation block com-
mand may have been sent by mistake. In this case, the automation must be
released.
8

PRODUCT MAINTENANCE

The product does not require particular maintenance; it is recommended to
clean the surface of the product (see chapter 1 – Recommendations for use).
English – 9