Kenwood TK-5400 Series Service Manual page 39

TK-5400
Item Condition
40. FM wide 1) Set panel test mode.
MIC Mode : WD
sensitivity CH : 1
check Signalling : 1
Toggle SW : A side
AG input : 1kHz
Deviation meter filter setting
LPF : 15kHz
HPF : OFF
PTT : ON
41. FM wide 1) Set panel test mode.
MIC Mode : WD
sensitivity CH : 1
check (TA) Signalling : 1
Toggle SW : B side
PTT : ON
42. FM 1) Set panel test mode.
NPSPAC Mode : NP
MIC CH : 1
sensitivity Signalling : 1
check Toggle SW : A side
AG input : 1kHz
Deviation meter filter setting
LPF : 15kHz
HPF : OFF
PTT : ON
43. FM 1) Set panel test mode.
NPSPAC Mode : NP
MIC CH : 1
sensitivity Signalling : 1
check (TA) Toggle SW : B side
PTT : ON
44. FM narrow 1) Set panel test mode.
MIC Mode : NR
sensitivity CH : 1
check Signalling : 1
Toggle SW : A side
AG input : 1kHz
Deviation meter filter setting
LPF : 15kHz
HPF : OFF
PTT : ON
45. FM narrow 1) Set panel test mode.
MIC Mode : NR
sensitivity CH : 1
check (TA) Signalling : 1
Toggle SW : B side
PTT : ON
38
ADJUSTMENT
Measurement
Test-
Unit Terminal Unit
equipment
Deviation Panel ANT
meter
Oscilloscope
AG Side Universal
Adjustment
Parts Method
Adjust AG input 15mV± 5mV
level to get a
standard MOD.,
3.0kHz DEV.
Adjust AG input 15mV± 5mV
level to get a
standard MOD.,
2.4kHz DEV.
Adjust AG input 15mV± 5mV
level to get a
standard MOD.,
1.5kHz DEV.
Specifications/Remarks